Page 1

BMW Brake Pad Sensor: An In-Depth Guide

People often ask questions regarding BMW brake pad sensors. Today, we have included everything to keep you updated about the pad sensors. You might want to check it out. Do you have to replace brake sensors of BMW? How to replace BMW brake pad sensor? These are some of the questions that appear quite often. So in this article, we are going to focus on those burning questions and try to come up with explanations that would be easy for you to grasp.

Some symptoms of a broken brake pad sensor ● ● ●

Warning light on the dashboard iDrive Message about brake pads Service Vehicle Symbol


How to replace it? Replacing a brake pad sensor is relatively easy if you know the basics and have your brake pads changed. It might take 30 minutes or less

Step 1 Determine which brake pad wear sensor you are aiming for- front or rear. Next, lift the vehicle using a jack and remove the wheel. Jack up the driver’s wheel if you’re replacing the front sensor and do the same with the passenger side wheel if you are replacing the rear one. Now, remove the wheel.

Step 2 After you have successfully removed the wheel, locate the brake sensor on the brake pad. The brake pad is located in the brake calipers. Using a flat head screwdriver, pry out the old sensor.

Step 3 Unhook the sensor from the brake caliper release valve. Now, open the black box mounted on the wheel well, you’ll find a connector inside. Then proceed to step 4.

Step 4 Pull the connector out of the box. Press the release tab on the connector to separate the wires. After you’ve separated the wires, install the new sensor.

Resetting BMW Brake Pad Wear Reminder Method 1: Reset BMW Brake Pad Sensor Turn the ignition on without starting the car. Then press and hold the reset button on the side of the dashboard. Wait for a few seconds and you will see the service menu appear at the center. Press the reset button several times until you see the symbol for the front of rear brakes. When you notice the brake symbol, press and hold the reset button until you see the words RESET. When RESET displays on the screen, release button and press it again for about 5 seconds to reset the brake light.


Method 2: Replace the brake lights using an OBD II scanner Try this method if Method 1 has failed. Nowadays, OBD-II scanners allow you to access the Condition Based Serving (CBS) menu and reset the brake mileage limit. In order to reset the brake light, a good scanner is necessary as it allows to read codes from the system and informs you about the underlying conditions that might have caused the problems.

Replacement costs BMW wear brake sensor replacement can cost from $6 to $30 if you are replacing it solely. However, with a mechanic in charge, it might cost in between $65 and $120.

Conclusion Here is your complete guide about the BMW brake pad sensor. We’ve have provided answers for your most burning questions by being specific about brake pad sensor such as instructions, costs, etc.

Profile for PartsCargo

BMW Brake Pad Sensor An In-Depth Guide  

PartsCargo is an online shop for OEM or aftermarket vehicle parts and accessories. PartsCargo has a huge stock of OEM and Aftermarket auto p...

BMW Brake Pad Sensor An In-Depth Guide  

PartsCargo is an online shop for OEM or aftermarket vehicle parts and accessories. PartsCargo has a huge stock of OEM and Aftermarket auto p...

Advertisement