CAMSHAFTS EAS24070
INSTALLING THE ROCKER ARMS AND PUSH RODS The following procedure applies to both cylinders. 1. Install: • Rocker arms “1” • Rocker arm shafts “2” (onto rocker arm base) NOTE:
The thread hole “a” of the rocker arm shaft must face to the outside.
1. Piston #1 TDC punch mark 2. Cylinder-#2 intake valve at its highest point
2. Install: • Rocker arm base (with rocker arms) • Push rods
i. Leave the camshaft drive and driven gears aligned for five minutes to allow the valve lifter to bleed. j. If necessary, repeat steps (h) and (i) to bleed other valve lifters. ▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Put the rocker arm base on the cylinder head. b. Install the push rods. NOTE:
EAS24060
• Be sure to correctly install the push rods between the rocker arms and valve lifters as shown. The illustration is viewed from the right side of the vehicle. • The lengths of push rod 1 and push rod 2 are different. Therefore, be sure to install them in the proper position. • Lubricate the push rod end balls with engine oil.
INSTALLING THE VALVE LIFTERS 1. Install: • Front valve lifter case • Rear valve lifter case • Valve lifters NOTE:
• Install the valve lifter in the correct place. • After installing the valve lifters, fill the tops of them with engine oil.
5-29