STILE AND RAIL PRODUCTION JIGS FOR CROWN RAISED PANEL DOORS Maximum size of stock 1-7/8” x 24” wide NORDIC - CRAFTER 1 PIECE SHAPER DOOR SYSTEM # 2475
This is a unique Shaper System for making Raised Panel Doors with arches or eyebrow patterns. It consists of only one jig that does both the arched raised panel and the arched rails. The jig will accept up to 1-7/8” thick x 24” wide stock. This will allow you to manufacture a maximum door size of 28” and minimum size of 9” using 2” stiles. The panel or rail is automatically centered in the jig by direct drive and not by a cable that will break or malfunction. The Nordic-Crafter utilizes two air hold downs for safety and also runs on a cushion of air for ease of operation. There are a total of 22 clear plastic patterns that allow you to see the cutter cutting at all times. Ten (10) patterns each for panel and rail as well as 2 straight patterns for straight or cope cuts. The Nordic-Crafter comes with 1 set of #2480 Patterns. Pattern #2481 and #2482 are not optional and are sold separately. Pattern #2480 has a 1-5/8” rise to top of arch. Pattern #2481 has a 2” rise. Pattern #2482 has a 1” rise to the top or eyebrow.
2480
2481
NORDIC CRAFTER - 1 PIECE ENTRY AND PASSAGEWAY DOOR SHAPER SYSTEM #2474 Maximum size of stock 2” x 28”
Has same qualities as #2475 Nordic Crafter as above only with four heavy duty pneumatic clamping cylinders. Has air flotation with thumb control on and off valve. Will make up to 36” wide doors with 4” wide stiles. This unique system is very cost effective and will save you hundreds of dollars. Comes with three straight plastic templates for you to make your own pattern.
NORDIC CRAFTER - 1 PIECE ENTRY AND PASSAGEWAY DOOR SHAPER SYSTEM #2473 Maximum size of stock 2” x 36”
As per above only will make up to 44” wide door with 4” wide stiles.
2 PIECE SET - CROWN AND RAIL JIG SYSTEM
Your panel is automatically centered over the desired pattern by the rack and pinion gear mechanism. This cuts the labor and errors down drastically and speeds up production as you don’t have to find center of the panel or rail for every size door. This setup is so simple and easy, you will wonder how you ever got along without it. We recommend that you rough-cut the crown panels and rails 1/8” oversize. Then run the pattern against the ball bearing rub collar to get the exact size and detail desired. The shaper cutters are on the bottom with the ball bearing on top. This way the pattern is always between your fingers and the shaper cutters for safety. Maximum opening in both jigs is 18”, which if you use 2” style, the widest door will be 22” The crown panel and rail patterns are interchangeable and are 18” long. They come 10 patterns to a set which allows you to make perfect patterns for your doors from 9” to 22” wide. They are made out of hard wood for long life and no damage to your shaper cutter if hit. TOOL NO. 2450 2451 2452 2455
ITEM Crown Rail Jig 1 Set of 10 Crown Rail Jig Patterns 1 Set of 10 Oval (arch) Rail Jig Patterns Large Crown Rail Jig for 30” Rails
CROWN RAIL JIG
TOOL NO. 2460 2461 2462 2465
CROWN RAIL PATTERNS
ITEM Crown Panel Jig 1 set of 10 Crown Panel Jig Patterns 1 set of 10 Oval (arch) Panel Jig Patterns Large Crown Panel Jig for 30” panels
CROWN PANEL JIG
40
CROWN PANEL PATTERN