Page 1

1

L141

Installation Instructions

Connect fixture wires to line voltage wiring (non-dimmable). Note: For dimmable fixture there will two conduit leads. One120V power and one dimmer lead.

CAUTION • Read all instructions.

2

Turn fixture upsidedown and insert the end into a Ø4” (Ø102mm) hole. Slowly turn fixture approximately 180° while pushing into the hole. Turn fixture so that reflector and trim are facing downwards.

• WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components.

Ø1

02 Ø4” mm

• Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation.

Push

• Turn off power before installation. • Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products.

n Tur

3

Press springs inward while pushing fixture up through hole. Allow springs to release once on the other side.

Pres

s in

Trim should now rest against drywall covering the hole opening.

T 604 708 1184 mplighting.com

Push

Copyright © MP Lighting All technical information in this document is subject to change.

• KEEP THESE INSTALLATION INSTRUCTIONS.

Version 10-2009


L141

Installation Instructions

To Remove Fixture

1

First remove the reflector by unscrewing counterclockwise.

TURN

CAUTION • Read all instructions. • WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components. • Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation. • Turn off power before installation. • Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products. • KEEP THESE INSTALLATION INSTRUCTIONS.

TURN

The twisting motion will cause springs to compress inwards allowing them to fit through the ceiling opening. Once through hole springs will release.

3

Slowly pull fixture out of hole rotating in the appropriate direction in order to fit fixture through the opening.

T 604 708 1184 mplighting.com

PULL

Copyright © MP Lighting All technical information in this document is subject to change.

2

Once reflector is removed grip trim firmly and pull while twisting clockwise.

Version 10-2009

/L141_inst  

http://www.mplighting.com/pdf/installation/L/L141_inst.pdf

Advertisement