Page 1

CIS 175 Final Exam (New 100 % Score) To Purchase This Material Click below Link FOR MORE CLASSES VISIT

Please check all questions included in this final Below

• Question 1 The image below is an example of what type of WAN connection? • Question 2 Which of the following is a type of coaxial cable? (Choose 2) • Question 3 Which of the following is a common Layer 2 protocol that could run over a dedicated leased line? • Question 4 SONET uses ________ cabling and offers high data rates, typically in the ________ Mbps— ________ Gbps range, and long-distance limitations, typically in the ________ km— ________ km range. • Question 5 The data rates for T3 link is ________. • Question 6 A common Layer 2 protocol used on dedicated leased lines is ________. • Question 7 If the bandwidth of an OC-1 link is 51.84 Mbps, what is the bandwidth of an OC-3 link?

• Question 8 When a wireless channel uses more than one frequency the transmission method called ________ spectrum. • Question 9 To protect WLAN traffic from eavesdroppers, a variety of security standards and practices have been developed, including all of the following except: • Question 10 WLAN security based on a PSK technology is called ________ mode. • Question 11 The wireless device that is marked X in the image below is a ________. • Question 12 WLANs can be categorized based on their use of wireless APs. The three main categories are ________, ________, and ________. • Question 13 Which is NOT a security threat for WLAN’s? • Question 14 Which of the following is one of the broad categories of wireless antennae that are based on coverage? (Choose 2) • Question 15 The Wide Area Network (WAN) design below represents what type of fault-tolerant network design? • Question 16 Which QoS design consideration is incorrect? • Question 17 Which term is best described by the following definition: “Both NICs are active at the same time, and they each have their own MAC address”? • Question 18

Which of the following is one of the two modes of Network Interface Card (NIC) redundancy? (Choose 2) • Question 19 The ________ command can be used to display information about current sessions, including source and destination IP addresses and port numbers. • Question 20 Which command is a UNIX command? • Question 21 A route can be added by using the route ________ command. • Question 22 Which command is a UNIX command? • Question 23 Which UNIX ARP option below is use to display current ARP entries in a UNIX Hosts’ ARP table? • Question 24 The ________ command can be used to see what a Layer 2 MAC address corresponds to a known Layer 3 IP address. • Question 25 The ________ command pings every router hop from the source to the destination and reports the round-trip time for each router hop. • Question 26 The ________ command displays NetBIOS information in IP-based networks. • Question 27 Which of the following is NOT a UNIX CLI command? • Question 28 Imagine that you have been troubleshooting a network cable (either copper or fiber optic), and you determine that there is a break in the cable. What would you use to identify exactly where the break exists?

• Question 29 What does the acronym PPDIOO stand for? • Question 30 Which of the devices shown is a Throughput Tester? • Question 31 When working with copper cabling (as opposed to fiber optic) a ________ can check a variety of a cable’s electrical characteristics. • Question 32 What kind of information would you find in an Application Log? • Question 33 What is the name of the instrument pictured below? • Question 34 What does a Throughput Tester do? • Question 35 Which of the approaches is used to determine the password of a system account or a user account? (Choose 2) • Question 36 Which of the following is NOT an example of an integrity violation? • Question 37 Which of the following is a firewall device type? (Choose 2) • Question 38 What type of integrity attack is described in the diagram below? • Question 39 What are the three primary goals of network security? • Question 40 What are the three types of malicious traffic detection methods?

• Question 41 What type of availability attack is described in the diagram below? • Question 42 ________ can occur when an analog connection creates an electromagnetic field around its conductors, inducing its waveforms on a nearby analog connection. • Question 43 What is the administrative distance of Routing Information Protocol (RIP) routing protocol? • Question 44 Which of the following is a common OSI Layer 3 (network layer) troubleshooting issue? (Choose 2) • Question 45 Look at the topology shown below. What is the design issue with this wireless network? • Question 46 Consider the network diagram presented below, let’s assume that both switches are capable of auto negotiating Ethernet speeds of 10, 100, and 1000 Mbps. Let’s also assume the switches do not support MDIX. Refer to the network diagram. Identify what the Layer 1 issue would be in this topology. • Question 47 What is the administrative distance of Open Shortest Path First (OSFP) routing protocol? • Question 48 What is the administrative distance of internal Enhanced Interior Gateway Routing Protocol (EIGRP) routing protocol? • Question 49 Out of these three steps above, the majority of a troubleshooter’s efforts are spent in which step?

• Question 50 Which of the following is a common OSI Layer 1 (physical layer) troubleshooting issue?.

Cis 175 final exam (new 100 % score)  
Read more
Read more
Similar to
Popular now
Just for you