Page 55

3 Operating conditions Operate the STD32 only with a supply voltage between 532V DC and have in mind the polarity! (see picture1) Use a stabilized power supply with minimum 1A output current. (we recommend to use only the original Telic power supply). If you use a mains adapter for power supply it has to conform with the VDE regulations. Devices with an operating voltage greater than 35 Volts which are connected to the relay have to be installed by a specialist observing the VDE regulations. Loads connected to the device are not allowed to exceed 1000 W per relay. The maximum voltage is 250 VAC (alternating current) The maximum switching power per relay is 6 A (depending on the width of the PCB tracks) When installing the device make sure that the supply cable has a sufficient diameter During operation the temperature has to be between -20째 and 55째 Celsius. The device is meant for operation in dry and clean rooms only. Protect the device from humidity, spray water and heat. In case of condensation allow a period of about 2 hours for acclimatisation. Do not operate the device in areas where inflammable gas, vapours, or dust are or could be present. Do not expose the device to heavy vibrations. The unit may only be repaired by a specialist. 55

Telic STD 32 Bedienungsanleitung  

Bedienungsanleitung des Telemetriemodules TELIC STD 32