How Lampwork Jewelry Is Actually Made If you've ever taken a good look at the different types of beads in beaded jewelry, you might have discovered lamp work jewelry before. An extremely specific kind of bead that's made of glass is what lamp work refers to. Each bead is normally made by hand through a careful process of heating glass and winding it or applying it to a prepared mandrel. The end outcome is a glass bead with beautiful designs that may sit under a glassy layer, or even be raised so as to give the bead texture. Here's some insight as to how these beautiful beads are in fact made. First, the tools need to be gathered. To begin with, you'll need rods of glass. To help you develop the design, it can help to have rods of different thicknesses. To get the base bead, you can start off with a thicker rod, and then go to the thinner rods to create the imaginative designs. You will want to assemble the colored glass rods that you will be working with, have a mandrel that has been dipped in bead release, and any tools that you would like to use to create textures (like a pick). In addition, you might want to consider safety gear like gloves and eyewear. Don't forget your torch for heating up the glass! Once you are ready and you have your torch turned on, you can begin heating up one of your rods. The tricky part here is figuring out how to turn your rod so the glass doesn't drip off in the bead-making process. The glass needs to be heated until you have formed a blob at the end, then you'll need to start heating up your coated mandrel. You will need to keep both the mandrel and the glass rod slowly turning. You'll then, carefully and slowly wrap the heated glass around the mandrel until you've formed the bead. You may use the heat of your torch flame to disconnect the bead from the remaining portion of the glass rod. You can continue spinning the bead in the flame to get the shape that you want. Once the bead is initially made, then you can add little embellishments to it by repeating the process. You'll be able to heat up some other rods of glass and place the heated parts to your beads, just be sure you only heat up the glass you are planning on using, especially when you are using the thinner rods. You can add these little embellishments by using picks or some other tools to make designs or various textures on the bead. You may have problems adding to the style of your bead, so make sure you keep the beads somewhat warm. You may want to anneal your beads overnight in a kiln, after you've finished making your bead and are happy with its look. This is especially a good idea if you plan on using your beads for jewelry or to sell them at a later date. As you can tell, there is a lot of preparation and work that goes into each and every piece of lamp work jewelry. It's a process that takes a lot of practice in order to master. You will be able to appreciate even more the effort and creativity that went into making it, the very next time you see this kind of bead on a piece of jewelry. Pacific Jewelry Designs was presented as the designer highlight in Bead Trends magazine for their top quality lampwork bracelet and necklace selection. To learn more about Pacific Jewelry Designs, pay a visit to their webpage at http://www.pacificjewelrydesigns.com/.
Pacific Jewelry Designs
How Lampwork Jewelry Is Actually Made
Document Tags: lampwork bracelet, lampwork jewelry, lampwork earrings, lampwork necklace http://www.pacificjewelrydesigns.com/
Pacific Jewelry Designs