4.7
Clearing the Buffer Memory
This function deletes the data sent to the cutting plotter. It is used to abort cutting while it is in progress.
MOVE TO R. MARK FEED
Step
Press the
AUTO PRE FEED TANGENTIAL AUTO REG. MARK
Step
DISTANCE ADJUST PAGE LENGTH
(PAUSE) key to switch to PAUSE mode.
2
Stop the transmission of data from the computer if this is in progress.
CLEAR BUFFER AXIS ALIGNMENT
1
Step
3
Press the
(NEXT) or
(PREV.) key until the following menu is displayed.
CLEAR BUFFER
PLOT AREA EXPAND ROTATE MIRROR
Step
4
Press the CLEAR
(ENTER) key to display the clear-buffer-memory menu. <YES>
COPY SORT RS-232C COMMAND BLADE WEAR SETUP
Step
5
Press the or key to select “YES” or “NO,” and then press the (ENTER) key. To cancel the selection, select “NO” and press the (ENTER) key, or press the (NEXT) or (PREV.) key.
PEN UP/DOWN TEST MODE PEN UP SPEED OFFSET FORCE OFFSET ANGLE STEP PASS INIT. DOWN FORCE LENGTH UNIT
4 – 21