Page 174

(k) (l) (m) (n)

(o)

(ii) The spoiler cannot extend rearwards more than 100mm maximum past the rear panel. (iii) The upper face of spoiler must not be greater in length and 250mm, regardless of angle. Cannot intrude past, or inside bottom line of rear window opening, regardless of length. (iv) Maximum height of spoiler to be 150mm measured from point of attachment, on a vertical plain. (v) Where side plates/panels are fitted, these must not exceed 500mm in length, measured from point of attachment on a horizontal plain, and must not overlap spoiler outline. (vi) The top edge of spoiler blade apex, to front of side panel attachment point, must be the shortest distance between these two points. Centre line of side panel to follow this line throughout its entire length. (vii) Body must retain original appearance when removed from the car, it must look like a car body and it must have front pillars. Must have a floor securely fastened within the box forming the rollcage and cover the area below the driver's feet. Minimum of 1.2mm steel or 1.6mm alloy. A 1.00mm steel or aluminium fireproof firewall must be fitted to completely isolate the drivers compartment from the engine compartment. Power bulge and air scoops allowed in bonnet but opening must not be to the rear. Maximum height of finished car 1.6 metres not including wing (spoiler). Maximum length of car not to exceed 1.4 metres from centre of rear axle. Overall body width maximum 1.68 metres, minimum 1.2 metres. Maximum flare width to be 100mm. The use of car bodies under specified measurements to be acceptable if original width. Body of car must be kept in good condition, and promoting bodies have the power to ask a competitor to upgrade his car before the next meeting.

2010 ELECTRONIC RULEBOOK

174

2010 NZ Speedway Rule Book  

2010 NZ Speedway Rule Book

2010 NZ Speedway Rule Book  

2010 NZ Speedway Rule Book

Advertisement