Page 48

Volume 1 – Lab 2

IPexpert CCIE R&S Detailed Solutions Guide

 Actually, if you assign a port to a VLAN that doesn't exist, it will get created for you. Cat3 , Cat4 int range Fa0/12 - 13 switchport access VLAN 90

% Access VLAN does not exist. Creating VLAN 90 Cat3(config-if-range)#

 So that's another way to create a VLAN without typing the command in. Cat3 & Cat4 int range Fa0/12 - 13 switchport protected Cat4(config-if-range)#do sh int Fa0/13 switchport Name: Fa0/13 Switchport: Enabled Administrative Mode: static access Operational Mode: static access Administrative Trunking Encapsulation: negotiate Operational Trunking Encapsulation: native Negotiation of Trunking: Off Access Mode VLAN: 90 (VLAN0090) Trunking Native Mode VLAN: 1 (default) Administrative Native VLAN tagging: enabled Voice VLAN: none Administrative private-VLAN host-association: none Administrative private-VLAN mapping: none Administrative private-VLAN trunk native VLAN: none Administrative private-VLAN trunk Native VLAN tagging: enabled Administrative private-VLAN trunk encapsulation: dot1q Administrative private-VLAN trunk normal VLANs: none Administrative private-VLAN trunk associations: none Administrative private-VLAN trunk mappings: none Operational private-VLAN: none Trunking VLANs Enabled: ALL Pruning VLANs Enabled: 2-1001 Capture Mode Disabled Capture VLANs Allowed: ALL Protected: true Unknown unicast blocked: disabled Unknown multicast blocked: disabled Appliance trust: none Cat4(config-if-range)#

 Note the protected state there...Next create the SVI on Cat3 and Cat4 Cat3 interface Vlan90 ip address 150.100.90.13 255.255.255.0

Cat4 interface Vlan90 ip address 150.100.90.14 255.255.255.0

72

Copyright © 2010 by IPexpert, Inc. All Rights Reserved.

v1500

R&S_Volume_1_DSG_v11.0_Lab2  
R&S_Volume_1_DSG_v11.0_Lab2  

IPexpert’s Detailed Solution Guide for the Cisco® CCIE™ v4 Routing & Switching Lab Exam Volume 1 At the beginning of each section, you w...

Advertisement