Page 47

Volume 1 – Lab 2

IPexpert CCIE R&S Detailed Solutions Guide

 And then finally trigger the traps on the interface in question. enabled by default.

They are not

Cat2 int Fa0/18 snmp trap mac-notification added snmp trap mac-notification removed


On Cat3 and Cat4, ensure that ports Fa0/12 and Fa0/13 are in VLAN 90. DO NOT use the VLAN database or any global configuration mode command to create this VLAN. Ensure that these ports cannot communicate with each other even though they are in the same VLAN. An SVI should be created so hosts can reach the outside world. Use as the network and .13 and .14 respectively.

 We do this a simple way or the hard way. In the lab, this choice is often determined by how many points we get for the solution. :)  The hard way would entail private VLANs' to assure complete isolation from one another. But we're only given one VLAN to work with. Private VLANs require at least two VLANs to work.  So first, let's start with the VLAN. VLAN 90 doesn't exist. Cat3(config-if)#do sh vl br VLAN ---1 12 40 80 100 300 567

Name -------------------------------default VLANB VLANC IT-Dept VLANA VLANF VLAND

666 IDS-VLAN 1002 fddi-default 1003 trcrf-default 1004 fddinet-default 1005 trbrf-default Cat3(config-if)#

Status Ports --------- ------------------------------active active active active active active active Fa0/1, Fa0/2, Fa0/3, Fa0/4 Fa0/5, Fa0/11, Fa0/14, Fa0/15 Fa0/16, Fa0/17, Fa0/18, Gi0/1 Gi0/2 active act/unsup act/unsup act/unsup act/unsup

 So we can create it. But, the lab says we can't do anything in global config mode or in VLAN database to create the VLAN. Anyone know VLAN-Making Voodoo Magic?


Copyright © 2010 by IPexpert, Inc. All Rights Reserved.



IPexpert’s Detailed Solution Guide for the Cisco® CCIE™ v4 Routing & Switching Lab Exam Volume 1 At the beginning of each section, you w...