Page 33

Volume 1 – Lab 2

IPexpert CCIE R&S Detailed Solutions Guide

Cat2(config-if)#do sh dot1x all Sysauthcontrol Enabled Dot1x Protocol Version 2 Critical Recovery Delay 100 Critical EAPOL Disabled Dot1x Info for FastEthernet0/6 ----------------------------------PAE = AUTHENTICATOR PortControl = FORCE_AUTHORIZED ControlDirection = Both HostMode = SINGLE_HOST ReAuthentication = Disabled QuietPeriod = 60 ServerTimeout = 30 SuppTimeout = 30 ReAuthPeriod = 3600 (Locally configured) ReAuthMax = 2 MaxReq = 2 TxPeriod = 30 RateLimitPeriod = 0 Dot1x Info for FastEthernet0/18 ----------------------------------PAE PortControl ControlDirection HostMode ReAuthentication QuietPeriod ServerTimeout SuppTimeout ReAuthPeriod ReAuthMax MaxReq TxPeriod RateLimitPeriod

2.12

= = = = = = = = = = = = =

AUTHENTICATOR AUTO Both SINGLE_HOST Disabled 60 30 30 3600 (Locally configured) 2 2 30 0

Cat1 Fa0/5 should temporarily bypass the listening and learning stage to transition directly into a forwarding mode.

 This should be a relatively simple question. At least once you get beyond the initial confusion of a vague question. Cat1 int Fa0/5 spanning-tree portfast

 You'll need to look at the diagrams and note which switch and port is involved. The "temporarily" word throws some confusion at you, although if a BPDU is received, it's will no longer be forwarding. But the only way to "bypass" any of the stages of spanning tree is to use portfast or to disable spanning-tree completely. Cat1(config-if)#do sh spann int Fa0/5 VLAN Role Sts Cost Prio.Nbr Type ------------------- ---- --- --------- -------- -------------------------------VLAN0567 Desg FWD 19 128.5 P2p Edge

 This doesn't verify the portfast state, but it will at least verify you are in a forwarding state, and not seen as a spanning-tree peer.

V1500

Copyright © 2010 by IPexpert, Inc. All Rights Reserved.

57

R&S_Volume_1_DSG_v11.0_Lab2  

IPexpert’s Detailed Solution Guide for the Cisco® CCIE™ v4 Routing & Switching Lab Exam Volume 1 At the beginning of each section, you w...

Advertisement