Page 1

S eSteU sn f osr -E IxM p oPAC d o mTeA R C H t up pI nIsnt sr ut rcut icotni o o

1

6

3

2

bolt the cupola shaft to cupola hub

2

stick the cupola shaft 1 through the hole in the

cupola hub

2

stick the Aluminium-pipes together and secure it with the snap buttons.

place a plastic-sheet on the ground and spread fabric on the sheet (tunnels upside). Then push the pipes into the tunnels (small plastic part on the backside). Please walk on fabric without shoes and take care about a clean ground.

4

8

5 5 2 3

4 1

place the cupola hub with the fixed cupola shaft into the center opening of the fabric. (the long part of the shaft on upper side). Then connect the frame legs to the cupola hub. Please mind to do this according to No. 1 - 5. Sliding the fabric inward towards the center opening will ease the legs connection to the hub.

598 Crane St, Lake Elsinore, CA 92530 22600 Temescal Canyon Road, Corona, CA 92883

ho an wr place the cupola fabric over the shaft and snap to the webbing loop along the tunnels. if applicable: place the cupola flag onto cupola shaft.

impactcanopy.com

Th all


on he alk round.

p to

a

S eSt eUtpu p I n Isnt rsutcr tui co tnisofnosr -E xI p d o mTe MoPAC o

7

6

3

1

2 2 2

push the round foot-pads into the frame-legs. The double-pulley should be placed in directon to the center of the dome.

2

2 1

1

2 one person is going under the fabric and raise the Dome with the cupola wrench. 1 the other person(s) lift and twist the frame legs in a straight position to the center-hub and pulling the fabric down towards the ground. 2 the one person is holding the cupola-wrench as long as the Dome is stable enough to stand itself.

8

pull down the fabric (on the metal ring) and thread the corner ropes through the either left or right part of the pulley - after that thread the rope upwards through the metal ring and then again downwards through the second side of the pulley. Finally pull at the rope and tighten the dome "step by step" at all legs. Then thread rope into the plastic-cleat 3 at the frame leg. Please ensure that all legs are tensioned equally throughout the Dome.

Security with anchor lines

9

thread the anchor lines (fixed on the tunnels) as wide as possible away from the dome and drive the stakes into the ground. Then fix the rope at the upper part of the stake. Furthermore drive the stakes through the hole at each footpad to fix the legs and secure the dome.

CAUTION ! During strong winds, snow or other unusual weather conditions it is recommended to break down the Dome in order not to cause any damages on material or personal health. We cannot be responsible for any causes if these instructions are not followed ! It is not a tent for 365 days/year.

Security with weight-bags 1

3

hold the cupola wrench to the bottom part of the cupola shaft and turn the wrench to raise the cupola until fabric becomes wrinkle free. Caution: do not over tighten !! Then take away the wrench and check again the tension at all legs.

22600 Temescal Canyon Road, Corona, CA 92883

2

Fill the weight-bag inlet with water/sand/stones/snow etc. and close the bag with the cord on the upper side of the bag. 1 Then sling the welcro-part around the foot-pad and place the bag as close as possible to the footpad on the inner side of the dome. 2 For transportation the 4 bags can be folded and stowed in one bag for easy carrying with the shoulder strap. 3

impactcanopy.com

Set_up_Expodome_USA  

http://www.impactcanopy.com/download/setup/Set_up_Expodome_USA.pdf