Page 73

EXHAUST SYSTEM

• Check the EXCVA to adjustment position. (!7-2) # Do not use the adjustable wrench to turn EXCVA pulley so as not to cause damage to the internal gear of EXCVA. • Install the pulley 8 to the shaft 9. NOTE: Make sure that the shaft’s line D and cable slots E facing upward as shown. • Hold the EXCVA pulley with an adjustable wrench, and then tighten the pulley mounting bolt to the specified torque. $ EXCVA pulley mounting bolt: 5 N·m (0.5 kgf-m, 3.5 lb-ft) # When loosening or tightening the pulley bolt, be sure to fix the pulley with an adjustable wrench, or EXCVA may get damaged. • After connecting the No. 2 cable 0, loosen the lock nut A and turn the adjuster B in or out until 8.5 – 9.5 mm (0.33 – 0.37 in) of the thread length F on the cable adjuster cam be provided and tighten the lock nut A.

# The cable slots of the EXCVA pulley must be located backward (adjustment position). (!7-2) NOTE: Install the rubber cover C correctly after inspecting it.

7-5

Reparatie Manuel M1800R deel 2  
Reparatie Manuel M1800R deel 2  

Reparatie Manuel M1800R deel 2

Advertisement