Page 65

FUEL SYSTEM AND THROTTLE BODY

AIR CLEANER CHAMBER AND THROTTLE BODY INSTALLATION Installation is in the reverse order of removal. Pay attention to the following points: • Connect the fuel injector couplers to the fuel injectors. Make sure that each coupler is installed in the correct position. The color on each lead wire refers to the appropriate fuel injector. Front injector lead wire 1: Y/R and Gr/B Rear injector lead wire 2: Y/R and Gr/W NOTE: Fit the clamp A to the lead wire. • Connect the TP sensor lead wire coupler 3 and STP sensor lead wire coupler 4. # TP sensor lead wire coupler and STP sensor lead wire coupler resemble each other very closely in external appearance. Make sure to check the color of coupler before installing. TP sensor lead wire coupler 3: Gray • Connect the throttle pulling cable 5 and throttle returning cable 6 to the throttle cable drum.

• Loosen each throttle cable lock nut. • Turn in each throttle cable adjuster fully and locate each outer cable so that the clearance is 0 mm (0 in). • Tighten each lock nut. • Adjust the throttle cable play. Refer to page 2-19 for details. • Install the air cleaner chamber and tighten the throttle body clamp screws as shown in the illustration. ("11-41)

0 mm (0 in)

0 mm (0 in)

6-21

Reparatie Manuel M1800R deel 2  
Reparatie Manuel M1800R deel 2  

Reparatie Manuel M1800R deel 2

Advertisement