REMOVAL FROM STORAGE

DO NOT start the engine until steps 1 through 9 have been done. 1.Fill the fuel tank. 2.Tighten the engine collant drain valve. Put coolant into the engine cooling system. 3.Check the engine oil level. 4.Check the condition of the engine fan belt and replace if required. 5.Check the hydraulic fluid level. 6.Use a petroleum base solvent and remove the Case Rust and

Corrosion Preventive from the hydraulic cylinder rods and spools. 7.Check drive chain compartments oil levels. 8.Replace fuel filter.

9.Remove air from the engine fuel lines. 10.Install the battery. 11.Remove the Do Not Operate tag. 12.Start the engine and run at idle speed for 2 minutes. Check for leaks around the filters and drain plugs. 13.Stop the engine and check the fluid levels of the engine, hydraulic system, engine cooling system and chain compartments.