FIRE OR EXPLOSION PREVENTION
!
● Sparks or flame can cause the
● If a fire extinguisher has been
hydrogen gas in a battery to explode. To prevent an explosion, do the following:
used, always recharge or replace the fire extinguisher before operating the machine.
1.When disconnecting the battery cables, disconnect the negative (-) cable first; when connecting the battery cables, connect the negative (-) last.
● Remove all trash or debris from the
2.When connecting jumper cables to start the engine, use the procedure shown in this manual on Booster Battery Connection.
torch on the machine, always remove the starting fluid container from the machine. Use compressed air to remove any ether fumes from the area.
machine each day. Especially check the engine area and exhaust system.
● If you weld grind, or use a cutting
3.Do not short circuit the battery posts with metal items.
● Starting fluid (ether) can cause injury or death. Do not breathe starting fluid vapors. Wear face protection when you remove or install a starting fluid container or when you use an aerosol spray starting fluid. Use starting fluid according to the instructions in this manual on Ether Starting Aid.
4.Do not weld, grind, or smoke near a battery.
● Sparks from the electrical system or engine exhaust can cause an explosion and fire. Before you operate this machine in an area with flammable dust or vapors, use good ventilation to remove the flammable dust or vapors.
hydraulic leak always repair the leak and clean the area before operating.
fuel can cause an explosion or fire. Do not fill the fuel tank with the engine running, if you are near an open fire, or if you are welding, smoking, etc. nonflammable solvent to clean parts.
● Keep the cooling system clean and maintain the correct coolant level.
● Make sure that you do not store
cleaning
oily rags or other flammable materials on the machine.
● A fire can cause injury or death.
● Check the electrical system for
Always have a fire extinguisher near or on the machine. Make sure the fire extinguisher is serviced according to the manufacturers instructions.
loose connections or frayed insulation. Repair or replace the loose or damaged parts.
● Before using a torch on the 13
machine, clean the area to be repaired.
TRIM THIS EDGE
RIGHT PAGE
Template Name: OM_1_col Template Date: 1994_04_29
● If the machine has an oil, fuel, or
● Engine
● Use
TRIM THIS EDGE
!
Alt= to hide template information Alt+ to display template information
SAFETY/DECALS/HAND SIGNALS
