STORAGE
REMOVAL FROM STORAGE Template Name: OM_1_col Template Date: 1997_02_06
DO NOT start the engine until steps 1 through 9 have been done.
9. Remove air from the engine fuel lines.
1. Fill the fuel tank.
10. Install the battery.
2. Tighten the engine collant drain valve. Put coolant into the engine cooling system.
11. Remove the Do Not Operate tag.
3. Check the engine oil level. 4. Check the condition of the engine fan belt and replace if required. 5. Check the hydraulic fluid level.
TRIM THIS EDGE
6. Use a petroleum base solvent and remove the Case Rust and Corrosion Preventive from the hydraulic cylinder rods and spools.
12. Start the engine and run at idle speed for 2 minutes. Check for leaks around the filters and drain plugs. 13. Stop the engine and check the fluid levels of the engine, hydraulic system, engine cooling system and chain compartments.
7. Check drive chain compartments oil levels. 8. Replace fuel filter.
Alt= to hide template information Alt+ to display template information 156
TRIM THIS EDGE Rac 0-00000 LEFT PAGE
