ECET 365 Week 3 Quiz Click Here to Buy the Tutorial http://www.tutorialrank.com/ECET/ECET-365-DEVRY/product-8255-ecet-365week-3-quiz-devry For more course tutorials visit www.tutorialrank.com 1. Question : (TCO #3) Which interrupt is non-maskable?
Interrupt from a device connected to IRQ pin of HCS12 microcontroller Both A and B Interrupt by multiple devices connected to IRQ pin of HCS12 microcontroller Comments:
2. Question : (TCO #3) Which of the following interrupts has the highest priority? Student Answer: TCNT timer overflow SCI0 ATD0 ATD1 Comments:
Question (TCO #3) Which selection is connected to the reset module in the HCS12 : microcontroller?
Student Answer: Reset pin ADC0 ADC1 None of the above Comments:
4. Question : (TCO #3) Which bit can mask a maskable interrupt? Student Answer: S bit Z bit N bit None of the above Comments:
Question (TCO #3) In the HCS12 microcontroller, the address range 0xFFFE â€“ 0xFFFF in : the interrupt vector table is assigned to which of the following?
Student Answer: Clock monitor fail reset ATD0 Reset COP failure reset Comments:
6. Question : (TCO #3) Freescale utilizes BDM to _____.
Student Answer: reset CPU by setting IRQ pin to high-level logic check changes in memory and CPU register for each instruction execution Both A and C
check each instruction of a program individually
7. Question : (TCO #3) Watch dog timer is a utility that _____.
can reset the microcontroller whenever a program locks up.
can catch errors due to memory corruption makes sure that a program does go to an unintentional infinite loop sequence Both A and B Comments:
8. Question : (TCO #3) When an interrupt occurs, _____.
in one stage, the contents of the CPU move to RAM memory
the CPU finishes executing its current instruction before it starts running an interrupt thread all interrrupts will be ignored if the I bit is zero Both A and B Comments:
Question (TCO #3) Which combination is an appropriate way of setting up the PORTJ : interrupt to enabled?
Student Answer: Pin I of CCR = 0 Pin I of CCR = 1 Pin I of CCR = 1 and PIEJ7 = 1 Pin I of CCR = 0 and PIEJ6 = 0 Comments:
Question (TCO #3) Which of the following interrupts has the highest priority immediately : after a microcontroller reset?
Student Answer: Reset XIRQ COP All have the same level of priority.
Published on May 1, 2014
Published on May 1, 2014
ECET 365 Week 2 Quiz ECET 365 Week 5 Quiz ECET 365 Week 6 Quiz ECET 365 Week 3 Quiz ECET 365 Week 4 Quiz ECET 365 Lab 1 Using the Serial Com...