Page 11

GPS Accessories Pole Bracket Kit for Pathfinder ProXRT

Radio Antenna Bracket for Tripod

Radio Antenna Mast Assembly

This pole bracket kit holds the Trimble® GPS Pathfinder® ProXRT receiver securely to any standard rover rod.

This bracket holds a radio antenna securely to a tripod leg. The heavy-duty bracket makes plumbing the antenna easy. It fits all full-size and heavy-duty tripods and uses a 1/2-inch-long, 5/8 x 11 male stud to secure the antenna or extension.

The SECO Antenna Mast Assembly will fit most heavy-dutytype tripods (like the SECO #520310) after the bolt assembly has been removed.



It is easy to attach and adjust the height on the rover rod. It comes with two pole clamps, one clip and two screws and the ProXRT is predrilled for the extra clip. The pole clamps are made of machined anodized aluminum with stainless steel clamp screws and fit rover rods with 3/4-in (1.90 cm) to 1-1/4-in (3.17 cm) diameters. Weighs 0.40 lb (0.18 kg)

It can be used with the SECO Six-Foot Snap Lock Radio Antenna Pole (5139-02XXX) or any Easy to extension clamp! with a male/female 5/8 x 11 connection. Weighs 1.55 lb (0.70 kg)

The mast telescopes to 7.5 ft (2.3 m) - plus your tripod height for maximum height. It’s easy to install and a hex tool is included. Convert your extra tripod to a radio base set-up! Weighs 2.5 lb (1.13 kg)

at s! r e TK n G r R t io a fo st se

d es Inclu bag! y r car 4 -10) (# 815


20 cm


Tech Tips available at

Antenna Bracket

Antenna Mast Bracket


The open clamp attachment allows quick and easy connection to the pole. It connects to 1-to-1.25 inch (25.4-to-31.8 mm) OD poles. The brass male 5/8 x 11 captive stud is easily removed for direct attachment of the radio antenna to the bar. The bracket comes with a non-slip Velcro® cable strap (#8124012) to help manage the radio cable. Weighs 0.22 lb (0.10 kg) It can be used with the SECO Radio Antenna Adapter (#2133-00) which adapts 1-1/8 x 18 radio antennas to any 5/8 x 11 threaded tip.


Radio Antenna Tripod with Antenna Mast

This bracket allows assembly of sections of standard diameter poles to obtain the desired height above ground of a GPS or radio antenna. It works with any standard 5/8 x 11 tripod and any pole sections 1to-1.25 inch (25.4-to-31.8 mm) OD poles. Easy and controlled setups are achieved by lifting one section at a time up through the bracket. 6-to-7 meters height is stable when using 1.25-inch sections. For windy conditions or higher setups a plate for attaching guy wires can be used.

#5300-11 — Hardwood/Fiberglass (shown) #5300-12 — Aluminum

Weighs 0.95 lb (0.42 kg)

Weighs 19 lb (8.62 kg)

This tripod with antenna mast gets your radio antenna to the desired height. The mast telescopes to 7.5 ft (2.3 m) and the tripod can be set to 5.5 ft (1.7 m) for a total elevation of 13 ft (4 m). The mast is aluminum with a male 5/8 x 11 tip. The tripod is the SECO #5302-10-ORG. The antenna mast (shown above) can be purchased separately to convert your own heavy-duty tripod as well (see #5561-20 above).

Contact us today for all your equipment needs!


Seco 2012 Catalog  
Seco 2012 Catalog  

Seco 2012 Catalog