Page 1

CURRERA-R Starter Kit BOB 144 description DB 25 for connecting system cable

Digital OUTPUTs and Digital Output +5V source

USB Digital INPUTs

1   2  3 4  GPO_VCC

1   2  3 4

Digital Input common GND GPI_COMM 4x

Power Supply Input (AUX)

RS-232

Digital Output common GND GPO_COMM 5x

Signals description Digital INPUT

Four user configurable, high speed, isolated current mode digital inputs with one ground common line (Digital Output GND). Can by used with 5V high side switched sources. (For maximum ratings see other site)

Digital Output common GND Common ground for Digital INPUT (Digital Input GND). Digital OUTPUT

Four user configurable, high speed, isolated open collector, low side switched digital outputs with one common ground (Digital Output GND). (For maximum ratings see other site)

Digital Output common GND Common ground for Digital OUTPUT (Digital Output GND). Digital Output +5V source

+5V source refer to Digital Output GND max. 60mA load.

RS-232

Standard serial port up to 1Mb/s

USB

USB 2.0 High speed interface. Maximum DC load of the USB VCC is 100mA.

Power Supply

External power supply input AUX_VCC - positive power pole (+12 to +48V) AUX_VSS - negative power pole (For maximum ratings see other site)

More information could be found on http://www.ximea.com/support/

www.ximea.com


Digital INPUTs (GPI1-4) Can be used with 5V level logic directly. For higher voltage levels serial resistor is needed so the input current will be effectively limited to 10mA. Rs = (VCC-1.5)/0.010-360[Ω] Resistor values for standard supply voltages are listed in following table. Minimum treshold current is 7mA. CURRERA digital I/O signals Digital INPUT x

Vcc Rs

Output

Digital Inputs GND

GND Signal source

VCC RS 5V 12V 24V

0Ω 680Ω 1800Ω

Maximum ratings Iin - 12mA Digital OUTPUTs (GPO1-4) Isolated open collector outputs, low side switched outputs. To get voltage level logic, external pull ups are needed. CURRERA digital I/O signals Digital Output 5V source + _

5V / 60mA

Digital OUTPUT x Resetable fuse

Digital Outputs GND

CURRERA digital I/O signals

Input

Digital Outputs GND

GND

GND

For TTL level logic Digital Output 5V source could be used as power source. Maximum ratings Vopen - 24V DC - Maximum open switch voltage Isink - 100mA - Maximum sink current per output Isource - 60mA - Maximum current load on Digital Output 5v source Power Supply Input Optional power supply 12-48V DC 7-13.8W. Maximum allowed ripple 200mV. Connecting wires to clamps (CAGE-CLAMP) To momentarily open clamping unit, use screwdriver and then insert stripped conductor. To open clamping unit for extended period, move locking slide toward conductor entry hole. Then fully insert stripped conductor and move locking slide back to original position.

More information could be found on http://www.ximea.com/support/

www.ximea.com

TTL device

Digital OUTPUT x

Input

Controlled device

5V (Dig. Out. 5V) External pull-up

BreakOutBox_BOB144_desc  

http://www.aprolink.jp/doc/dldata/support/XI/CurreraR/English/BreakOutBox_BOB144_desc.pdf