Page 1

Instrument

V -Light

Wireless LED Light Curing Device


V â–Ą Features Sophisticated Design Simple & Easy Interface Various Working Modes Super Capacity Battery Automatic Inactive & Automatic Power Off Universal Usage To All Resin Materials

V

-Light

Wireless LED Light Curing Device


V â–Ą Composition

Charger Stand Battery Pack Handpiece Anti-glare Shield Light Guide Power Supply


V â–Ą Installation

Connect the plug of power adapter to charger stand, and set the stand on a flat surface. When installed properly, the green power indicator will be on.

Put the battery pack to handpiece paying attention to the direction.

Put to slide the light guide to the handpiece tightly, or it might be fall out, or can be a cause of lower output of the power.

Put the anti-glare shield from the point of light guide and set it on a proper position.


V â–Ą User Interface Mode Time Indicator Time Set Start / Finish

Overheat Indicator

Battery Voltage Level

Mode Set


V □ Modes

Normal Mode

High Mode

Turbo Mode

■ Optical Output

■ Optical Output

■ Optical Output

650mW/cm² (± 10%)

1200mW/cm² (± 10%)

1600mW/cm² (± 10%)

■ Time setting

■ Time setting

■ Time setting

10, 15, 20, 30 sec.

5, 10, 15, 20 sec.

3, 5, 10, 15 sec.


V □ Modes

Soft Start Mode

Soft Start Mode

■ Optical Output

■ Optical Output

Gradually increasing 0~1600mW/cm² (± 10%)

Repeat 0 and 1600mW/cm² (± 10%)

■ Time setting

■ Time setting

10, 15, 20 sec.

10, 15, 20 sec.


V □ Output Check

300mW/cm² (± 10%)

● ●

600mW/cm² (± 10%)

● ● ●

900mW/cm² (± 10%)

● ● ● ●

1200mW/cm² (± 10%)

● ● ● ● ●

1600mW/cm² (± 10%)

Put the end of the light guide at the middle of the oval shaped indicator and irradiate light. You can check and see the optical output instantly. Please note there can be occurred an accidental error depends on the location and angle of the light guide.


V □ Charge Check

Charging

Fully Charged

Power

Power

■ When the power connects to charger stand, the green power indicator will be on. ■ Upon putting handpiece on the charge stand, the red indicator will be on and start to charge. (If your battery of handpiece is fully charged, the red indicator will not be on) ■ When charging is finished, the red indicator will be off.


Thank you. Making the World Smile

www.vericom.co.kr

V-Light  

Lámpara de polimerización de última generación