F-3000 Series User Guide

CAUTION (during use) 1. Should height adjustment be required, you should tightly hold the stand pipe of the unit with one hand, then twist the tightening nut with another hand. Ensure the steamer is switched off during any adjustments, and is not pointing you or anyone else, so as to prevent injury.

2. The water vessel protector is used to prevent scalding by accidental touching the hot jar while working. Always ensure the protector is fitted and in place before use.

3. When installing/fitting the water container, do not fasten the container securing support too tightly, over tightening may damage the rubber jar ‘seal’ or shorten its lifespan. Over tightening may cause cracking of the glass water jar, and possible damage to the heater element.

4. The water level should be filled between the “MAX” & “MIN” level displayed on the side of the water vessel during use. Incorrect levels may result in injury.

5. When adding water via the filler cap, always unplug the unit from the mains supply.

Care should be taken to avoid spillage and prevent leakage into the steamer housing and possible electrical shorting of the device.

6. If steam or water leakage is visible from the main housing during use. Switch off the “POWER” button immediately, and disconnect from the mains power supply. Then remove the water container and check to ensure rubber seal is seated properly, then reinstall it Also check the main filler cap housing to ensure the seal is correctly fitted. If nothing is improved, please consult the sales agent.

7. When operating the steamer, the nozzle must not be aimed at client’s face until the vapor has begun to spray out thinly and evenly, keeping a minimum distance of 40 cm from the face, the vapour should be sprayed between the client’s jaw and neck area, to the top of the face/hairline.

8. Since the ozone (when used) kills skin bacteria, it is not recommended for use over a prolonged time, the usage times should be according to the client skin types (see below).

9. During continuous use, when water level falls below the low limit the following will occur:F-300A the machine will automatically turn off the heater element, at freeze the function of all the buttons keys, except the “VAPOR” button. This will be accompanied with a constant buzzing alarm, which will not stop until the water is added to the normal level. Then repress the ‘VAPOR’ key to proceed with operation. NEVER attempt to use the steamer with no water in the vessel, as damage may occur to the unit.

F-300B the machine will automatically turn off the heater element by cutting off the power supply.

Unless the timer unit has completed its cycle, add some water to continue operation. The machine will automatically resume steaming in approximately 1-3 minutes after adding water. NEVER attempt to use the steamer with no water in the vessel, as damage may occur to the unit.

10. The steamer/machine should only be used with an earth grounded mains supply.