Page 1

Mitre bandsaw machines

CPI


SAWHEAD / SAW DRIVING

FASTENING CLAMPS

Sawhead: It is built in one only piece, in electrowelded and stabilised steel.

Made by both sides of blade.

Sawhead is guided hydraulically on prismatic twin columns and lineal bearings.

Automatic positioning of the clamps.

Both columns are filled in with concrete polymer to avoid vibrations.

The fix clamp is grooved and tempered to avoid wearings when feeding.

Saw driving: High performance gearbox, specially sized for great loads at low revolutions. Motorized cleaning brush and air-oil mist spray allow getting a longer bladelife.

AUT OMAT IC GUIDI NG / AUT OMAT IC TENSIO NING

A U T O M AT I C M I T R E POSITIONING CNC

Automatic guiding: Guiding is made with a combination of bearings and hard metal plates, allowing any readjust of blade’s position. Mobile blade guiding arm is blocked hydraulically to avoid vibrations. Automatic tensioning: An hydraulic cylinder keeps always the correct blade tensioning.

Automatic mitre positioning CNC +45º, -60º Accurate ball malformations.

bearing

to

avoid

It is made by a gearbox that activates a rack/pinion system specially designed. Mitre positioning control by CNC.


OT H E R S AW I N G A N D D R I L L I N G S O LU T I O N S

Vertical cutting

Drilling units

Plasma cutting

Complete solutions

Este documento no es contractual. DANOBAT se reserva el derecho de realizar los cambios que considere oportunos, sin previo aviso. El contenido grรกfico de este catรกlogo es propiedad de Danobat. 09/2009

Horizontal cutting

DANOBAT

Arriaga kalea, 21 - P.O. Box: 28 E-20870 ELGOIBAR (Gipuzkoa) Spain

Tel.: + 34 943 74 81 50 / +34 943 74 80 44 Fax: + 34 943 74 81 82 salessaws@danobat.com www.danobat.com

DANOBAT CPI mitre bandsawing solutions  

CPI Mitre bandsaw machines Automatic mitre positionig CNC +45º, -60º Made by both sides of blade. Automatic positioning of the clamps. The f...