Page 1

AntiLax Voltage setting Plug the main board and turn the device, and follow setting method below. PT5V (+) and upper GND (-), set for 5V on VR2 PT2.5 (+) and upper GND (-), set for 2.5V on VR3 RF5V (+) and lower GND (-), set for 5V on VR4 clock wise direction for increase, and counter clock wise for decrease.

Out (+) and lower GND (-) Go to 0215 mode, pick any DA address, set DA value to RFV box, input 1000. Check the output, it should be shown 2.5V On the oscilloscope should be shown about 100-105 Vrms.

If monopolar part board changed, please also set the voltage.

(-) (+) VR1 (clock wise direction for increase, and counter clock wise for decrease) Put on HP and turn on the machine, set 5V. When do the setting make sure plus and minus terminal don’t short, otherwise it can cause one of the IC died.

Antilax voltage setting  
Read more
Read more
Similar to
Popular now
Just for you