Issuu on Google+

An All-Position Electrode for Build-Up and Cushioning of Steels

EutecTrode 4002 ®

WELDING • High compressive strength • Excellent resistance to severe impact with mild abrasion • Fully machinable


DESCRIPTION:

WELDING PARAMETERS:

EutecTrode 4002 has been formulated to resist severe impact on plain carbon steels, low alloy steels, and many construction steels. Deposits have high compressive strength that makes them ideal for re-builds involving a cushion layer followed by a harder final hardface.

Preparation: Clean weld area of scale and/or oxide. A nominal preheat of 150°F is advised if part is below 40°F or over 1” thick. For higher carbon steels higher preheats will be needed. Check the Reference Section of the Eutectic Data Book or call Eutectic Technical Services for information regarding specific preheating levels for specific steel grades.

TYPICAL APPLICATIONS:

Technique: Deposit stringer beads or 2x to 3x weave beads. Excessive weaving is not advised as wide beads can cause excessive base metal overheating and degrade the weld deposit wear properties. Back whip craters to reduce crater-cracking tendencies. When de-slagging make sure to thoroughly remove slag at the weld deposit toes.

• Slideways • Wheel crowns • Guides & couplings • Rope winches • Brake drums

TECHNICAL DATA: Typical Hardness as-deposited (HRC) 28 – 30 average Current & Polarity: DCEP (+) and AC

Post-welding: Allow parts to slow cool in still air. High carbon steels and air hardenable steels should be covered with a heat-retardant blanket. When machining is needed use tool set-up and speeds typically used with fine-grained pearlitic steels

Availability and Recommended Amperages Dia.

1/8“ - 3.2mm

Amp.

90-110

5/32“ - 4.0mm 3/16“ -(4.8mm) 120-180

205-245

YOUR RESOURCE FOR PROTECTION, REPAIR AND JOINING SOLUTIONS Eutectic Corporation N94 W14355 Garwin Mace Drive Menomonee Falls, WI 53051 USA P 800-558-8524 • F 262-255-5542 www.eutecticusa.com

Eutectic Canada 428, rue Aime Vincent Vaudreuil-Dorion, Quebec J7V 5V5 Phone: (800) 361-9439 Fax: (514) 695-8793 www.eutectic-na.com

Eutectic Mexico KM 36.5 Autopista Mexico-Quertaro 54730 Cautitlan-Izcalli Estado de Mexico, Mexico Phone: 011 (52) 55-5872-1111 e-mail: eutectic@eutectic.com.mx

Statement of Liability: Due to variations inherent in specific applications, the technical information contained herein, including any information as to suggested product applications or results, is presented without representation or warranty, expressed or implied. Without limitation, there are no warranties of merchantability or of fitness for a particular purpose. Each process and application must be fully evaluated by the user in all respects, including suitability, compliance with applicable law and non-infringement of the rights of others, and Eutectic Corporation and its affiliates shall have no liability in respect thereof. 4002-04-24-12© 2008, Eutectic Corporation, ® Reg. T.M., Printed in the U.S.A.


EutecTrode-4002