__MAIN_TEXT__

Page 4

which it was purchased together with proof of purchase and installation date, failure date and supporting installation date. Unless otherwise provided, the distributor or dealer will contact PressurePak Inc. for repair instructions. Any defective PressurePak unit to be returned to PressurePak Inc. must be sent freight prepaid; documentation supporting the warrant claim must be included if so instructed. PRESSUREPAK INC. WILL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSSES OR EXPENSES ARISING FROM INSTALLATION, INCLUDING MERCHANTABILITY OR FITNESS FOR A PARTICULAR PUPOSE, WHICH EXTEND BEYOND THOSE WARRANTIES DESCRIBED OR REFFERED TO ABOVE. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages and some jurisdictions do not allow limit actions on how long implied warranties may last. Therefore, the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from jurisdiction to jurisdiction. Any questions or inquiries regarding this warranty or any PressurePak water system products may be directed to PressurePak Inc., 925 Freedom Blvd., Watsonville, California 95076; Telephone (831) 786-9976; Fax (831) 722-2276.

CHARACTERISTICS The three most important characteristics of the PRESSUREPAK™ Systems: 1. Plug and play design enables simple installation with three connections: a. Low pressure water pipe “IN” hook-up b. Hi pressure water pipe “OUT” hook-up c. Electrical connection d. 110 15 Amp, 3 Amp U ground plug e. 220 20 Amp, 3 prong twist-lock plug 2. Variable speed (PP-1-22-GPM), submersible, constant pressure pump technology: a. Performance proven reliability b. Greater flow curves at lower power consumption c. Soft start which prevents water hammer d. Relatively quiet operation 3. Everything in one box engineering makes it possible to solve complex water pressure problems in one service call. SIZING GUIDE 1. Determine approximately how much water pressure you have available at your water inlet. 2. Determine how much water pressure you require at maximum flow. 3. The pressure difference between you available pressure (1 above) and your required pressure (2 above) is the PSI Boost Needed for you.

Profile for CareerSource Magazine

PPak Owner's Manual  

ppak owner's manual

PPak Owner's Manual  

ppak owner's manual

Advertisement