Page 1


thank you for purchasing this BReRA watch. this timepiece was manufactured and assembled using the most refined technology, materials and attention to detail, resulting in the highest level of precision and accuracy. the following instructions are provided to help you familiarize yourself with the proper operation and care of your timepiece. to ensure correct use, please read and follow these instructions carefully.

PRODIVER 1. Chrono Second Hand 2. Minute Hand 3. Hour Hand 4. Chrono Minute Hand 5. Second hand 6. Date Window 7. Adjustable internal bezel A. Crown B. Date C. Time D. Screw crown adjustment internal bezel for dive time setting E. Dive time adjustment


C Pulsante A

1 2 3 4 5

Pulsante B


6 7

SETTING THE TIME: • Gently unscrew the crown to position C (the watch stops). • Turn the crown until you reach the correct time. • Push the crown back into position A. SETTING THE DATE (quick mode): • Pull out the crown to position B (the watch continues to run). • Turn the crown until the correct date [ 1 ] appears. • Push the crown back into position A. Caution: never correct date between 9 pm and 0.30 am.

USING THE CHRONOGRAPH: • The chronograph is able to measure and display time in 1/1 second up to maximum of 59 min. 59 sec. ADJUSTING INTERNAL BEZEL FOR DIVE TIME SETTING: • Gently unscrew the crown (D) to position (E). • Adjust dive time setting bezel and align the minute hand with the "0" of the adjustable internal bezel. • Push the crown back into position (D). MEASURING TIME WITH THE CHRONOGRAPH: • The chronograph can be started and stopped each time pusher (A) is pressed. • Pressing pusher (B) resets the chronograph and all the hands return to their zero positions. RESETTING THE CHRONO TO ‘12’ POSITION: • Gently unscrew crown to position (C). • Press top pushers (A) realign chrono hand manually to "12" position. • Push the crown back into position A and rescrew. • To test, press top pusher (A) for 5 seconds and push again to stop. Press bottom pusher (B). Chrono should reset to "12."

brera international warranty Your BRERA watch is warranted against defects in materials and workmanship by BRERA under the terms and conditions of this warranty for a period of two (2) years from the original date of purchase. This warranty only covers the following components: the watch movement, hands and dial. Should a covered component be defective in materials or workmanship during the warranty period under normal use, it will be repaired or the watch will be replaced (at the sole discretion of the service center) free of repair charges. A copy of the receipt or completed, dated, stamped and signed BRERA International Warranty card is required for proof of purchase. A $14.95 return shipping and handling fee will apply to all warranty service in the US. International warranty shipping and handling fees may vary.

THIS WARRANTY DOES NOT COVER: • Battery*, Case, Crystal or Strap •D  amage resulting from improper handling, lack of care, accidents, negligence or normal wear or tear (e.g. scratched crystal, alteration of the color and/or material of non-metallic such as leather, rubber and discoloration of IP plating).  ater damage even if marked “water-resistant.” •W  OTE: Water resistance of watches is rated based on laboratory pressure tests based on a static position. As N many water-based activities involve a lot of movement and other environmental factors, it is not recommended to submerge watches in water for a long period of time. Our water resistance rating does not take into account sudden, rapid and repeated water pressure changes, high water temperatures ( showers, baths, hot tubs and Jacuzzis are not recommended for your BRERA timepiece) and sudden changes of temperature. Steam can pass through a rubber gasket and, at times, cause condensation on the crystal. Over time, this could cause the movement to rust. Bath soap is also a fine level abrasive and can wear down watch links, cases, crowns, etc. Always wipe or clean your watch with a lightly dampened microfiber cloth to maximize the life and water resistance of your watch.

This warranty is void if the watch has been damaged by accident, negligence, unauthorized service, or other factors not due to defects in materials or workmanship. In case of replacement, BRERA cannot guarantee that you will receive the same model watch. If your watch is not available, a watch of equal value or similar appearance will be provided. *IMPORTANT NOTE: Using the chronograph function for more than 30 minutes per day will SIGNIFICANTLY reduce the life of the battery of your quartz movement.


Profile for BreraOrologi

Brera Orologi - Manual Instructions Prodiver Collection  

Brera Orologi - Manual Instructions Prodiver Collection  

Recommendations could not be loaded

Recommendations could not be loaded

Recommendations could not be loaded

Recommendations could not be loaded