Page 1

Specialized Know How: Increasing SolidWorks Performance, MEMORY and EXCHANGE Document MEMORY

You're likely to use when deciding just how much RAM is needed for a workstation it's most significant to know what's needed of one's design and the strategy. There's a potential to over get, so it's also very important to observe that any quantity of RAM over what's needed will soon be abandoned. The chart above represents that, for the design and environment, something over 10GB of RAM is sufficient. The workstation is forced by anything under 10GB to start paging. The more the workstation pages the slower it goes. The most crucial point to consider is that it's cheaper to over get RAM than have your technicians and designers awaiting some type of computer. EXCHANGE EXCHANGE (a.k.a. Digital Memory or Page File) and RAM work together if you find insufficient RAM obtainable in the workstation Rental. Where it's usually recommended to have enough RAM to prevent using SWAP, it's also recommended to have a SWAP document designed. With no SWAP document a workstation will end up unstable because it approaches the limit of installed RAM. When establishing a SWAP file you've 2 options; allowing the machine control the SWAP file for you vs. Establishing the SWAP document your self. Automatically, the OS is placed to handle the SWAP document. This is often harmful when utilizing SolidWorks.


The chart above not only demonstrates once the system began opening the system handled SWAP document, but that the standard wouldn't complete and it became unstable that our test went 10 to 13 percent slower. SolidWorks started exhibiting warnings that the machine was running low on memory until it in the course of time failed.

Still another issue that needs to be considered when considering SWAP is drive speed. The assessments above were run with the OS living and the SWAP on 2 Intel strong state hard disk drives as RAID 0 designed. If the SWAP file is then switched by us to just one 7200 RPM standard difficult drive; the performance hit is obvious.

Evaluating the workstation with 6GB of RAM, the time is increased by the slower hard drive to finish the standard by 250%. With 8GB of RAM, the time to complete improved 160%. When the workstation begins using SWAP, the pace of the drive becomes much more significant. Again, it's better to prevent the need for SWAP in most conditions and configure a has enough RAM for your designs and sufficient space to develop to the potential of one's future models. Our check standard had a of 5:01:35 and we measured time for the regions of Opens, Rotations, Modeling, Rebuilds, Switching Sheets, Saves and Closes In the event that you recall from our first article;. Despite the fact that 10GB of RAM was adequate for our construction we ran our optimum put up of 24GB of RAM for this examination and our macro ran in 2:16:41, this had an obvious impact in the regions of Opens, Rotations, Modeling, Switching Sheets, Saves and Closes. That change obtained us a savings of 2:44:54 or 54.7%.

Specialized Know How: Increasing SolidWorks Performance, MEMORY and EXCHANGE Document  

You're likely to use when deciding just how much RAM is needed for a workstation it's most significant to know what's needed of one's design...

Read more
Read more
Similar to
Popular now
Just for you