Page 1

www.raptoruk.co.uk

+44 (0) 1977 680444


Parts Identification

Kudos 3F Deployment & Recovery

Module 1

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


Parts Identification

Kudos 3F Deployment & Recovery

Module 2

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


Parts Identification

Kudos 3F Deployment & Recovery

Module 3

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


Parts Identification

Kudos 3F Deployment & Recovery

2 x Roofs

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


Parts Identification

Kudos 3F Deployment & Recovery

2 x Floors

Made in UK

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


Parts Identification

Kudos 3F Deployment & Recovery

2 x Floor Support Bars

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


Assembly Instructions


Total steps: 34

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


1

Assembly Instructions

NB - Ensure ground is as level as possible.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


2

Assembly Instructions

NB - Identify all parts you will need from the previous section.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


3

Assembly Instructions

NB - Only ever disengage panels from the frame pins where indicated on the panel with the triangular sticker.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


4

Assembly Instructions

NB - Ensure module orientations are as pictured in the parts identification section.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


5

Assembly Instructions

Start with module 3, raise the module to upright placing it on its feet. Remove the top pin to the RHS when looking at the blank panel. With a pry bar lift the blank panel off the frame pin where the disengage sticker is located.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


6

Assembly Instructions

Open the panel 90 deg to the frame so the module can now stand up. Refit the top pin. Leave the window air con panel as shut.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


7

Assembly Instructions

Raise module 2 to upright placing it on its feet. Remove the top pin to the RHS when looking at the blank panel. With a pry bar lift the blank panel off the frame pin where the disengage sticker is located, open the panel 90 deg to the frame so the module can now stand up. Repeat for the other panel so you form a Z with the frame and 2 panels, refit the top pins.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


8

Assembly Instructions

Join module 3 to module 2 by dropping the panels that are open onto the corresponding frame, remove and refit the top pins accordingly.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


9

Assembly Instructions

Drop in the floor support bar to connect frame to frame. Insert a floor panel in to the guide tracks and push to fit, use the floor panel to square up the assembly, adjust the module to suit.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


10

Assembly Instructions

Fit a floor end gasket and push the floor onto it, trim to length with a Stanley knife.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


11

Assembly Instructions

Raise module 1 to upright placing it on its feet. Remove the top pin to the RHS when looking at the blank panel. With a pry bar lift the blank panel off the frame pin where the disengage stick is located, open the panel 90 deg to the frame so the module can now stand up. Refit top pin.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


12

Assembly Instructions

Join module 2 to module 1 by dropping the panel that is open onto the corresponding frame, refit the top pin.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


13

Assembly Instructions

Open the window door panel to 90 deg.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


14

Assembly Instructions

Drop in the 2nd floor support bar to connect frame to frame, Insert a floor panel in to the guide tracks and push to fit, use the floor panel to square up the assembly, adjust the module to suit.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


15

Assembly Instructions

Once square fit a floor mid gasket and push the floor onto it. Trim the gasket to length and leave it just engaged, final fitting will be done when the second floor is in and the end gasket is in.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


16

Assembly Instructions

Shut the window door panel and refit the top pin. Fit the final floor end gasket under the door and window, trim to length. Now finally knock down the centre gasket so it goes all the way home.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


17

Assembly Instructions

Fit the door handle set to the door lock.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


18

Assembly Instructions

NB - Ensure all top pins are fully home and the top of the cabin assembly is level. Adjust the feet if required.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


19

Assembly Instructions

WARNING DO NOT FORCE THE ROOF DOWN IF THE CLIP AND RECEIVER ARE NOT ENTERED IN TO EACH OTHER AS THIS WILL CAUSE DAMAGE TO OR BOTH THE SECTIONS.

Lift a roof panel onto the top of the assembly, position the edge over the middle of the central frame, carefully locate the roof down stand clips over the receiver sections on the top of the side panels, ensure the down stand at both sides is sat as engaged into the clip section, once all alignment is good gently pull the roof panel down into the clip at 1 side then repeat at the other side.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


20

Assembly Instructions

Once the receiver and clip enter into each other work from one end to the other and the mating of the top section will be engaged as 21 and 22.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


21 / 22

Assembly Instructions

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


23

Assembly Instructions

Fit the 2nd roof panel as 19/20/21/22.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


24

Assembly Instructions

Roll out the roof shroud on the roof ensuring the ratchet is at the window air con end.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


25

Assembly Instructions

Fit the shroud over the cabin roof corners ensuring it sits flat to the roof panels, pull up the ratchet and strap so that the shroud grips the roof to the cabin walls, DO NOT OVER TIGHTEN.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


26

Assembly Instructions

Tuck the cover flap over the ratchet.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


27

Assembly Instructions

Connect your electrical supply to the blue coupler that is mated to the cabin power umbilical cable.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


28

Assembly Instructions

Unpack the air conditioning unit, drop down the air con holder flap and sit the air con unit in place from the outside, position it flush to the inside so the rubber seals seal around it, plug the air con into the fly lead and into a socket on module 2, follow the operating instruction in the box for operation and maintenance.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


29

Assembly Instructions

Unpack the heater, fit the legs and plug in ready for use. Set the programmable functions as per the instructions in the box.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


30

Assembly Instructions

Commission the electrical system once the power is supplied and check for function, see the LED light set up and adjustment leaflet if adjustment is required.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


31

Assembly Instructions

Function check the door lock, all opening windows.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


32

Assembly Instructions

Function check the fly screens and black out blinds.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


33

Assembly Instructions

Your Kudos 3F is now deployed and ready for use.

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444


34

Assembly Instructions

Recovery is by reverse of these instructions

Made in UK

www.raptoruk.co.uk

+44 (0) 1977 680444

Kudos 3F Deployment & Recovery  
Kudos 3F Deployment & Recovery  
Advertisement