Page 130

INSP ADJ

CONTROL SYSTEM

E Start-in-gear protection device adjustment (MH models) 1. Check: 9 Start-in-gear protection device operation Incorrect → Adjust. 2. Adjust: 9 Start-in-gear protection device cable Adjusting steps: 8 Set the shift lever in the neutral position. 8 Loosen the locknut 1. 8 Adjust the start-in-gear protection device cable adjusting nut 2 so that the point on the wire connector 3 aligns with the mark a on the flywheel cover. 8 Tighten the locknut. NOTE: Shift the shift lever into neutral and make sure the starter can be pulled. If it cannot be pulled, repeat the above procedure.

3-10

Yamaha f15amh, f15mshx outboard service repair manual s 001432  
Yamaha f15amh, f15mshx outboard service repair manual s 001432  
Advertisement