1 2 3 4 5 6
General repair guidelines Crimp tool and use Installation guidelines - CA - B / CA - COM - B cable connector Installation guidelines - KPSE cable connector Installation guidelines - SURE SEAL cable connector Installation guidelines - DEUTSCH cable connector
1. General Repair Guidelines When working with cable connectors, the following must be observed:
Keep hands, work place and connectors clean, dry and free of grease. Always use the special installation tool - see paragraph 3.1.31 - for installation. For CA - COM - B connectors use the same special tool as for CA - B connectors. Check tools for wear before use - a wrong or defective tool as well as improper handling can damage the cable connector components. When cutting cables to proper length, make sure they are the same length and the cutting edge is straight. Do not compress or squeeze the cable. For 90 ° cable routing, cut the cable to proper length when in angled position. The cable covering must reach under the crimp joint. Check installation guidelines for correct length to be stripped. When stripping the cable, make sure that the individual wires are not damaged, kinked, bent or soiled. Before installation, check crimp connections of all contacts: - Individual wires must be visible in the inspection hole of the contact. - All wires must be tightly caught in the crimp connection. - The wire insulation must reach the contact. When removing and reinstalling contacts, make sure to check the flow direction and use isopropyl alcohol (rubbing alcohol) as a lubricant, do not twist contacts and tool. Do not reuse damaged parts. Contacts in size 60/100, 160 and 500 can only be crimped hydraulically. If these contacts are damaged, the complete wire must be replaced. Make sure all parts are positioned correctly, check charts!. On straight cable feeds, insert the contacts from the center to the outside. On 90° cable feeds, insert them in a row from the bottom to the top. Even contacts, which are not wired, need to be installed. Close off any empty chambers with a plug. Visually check if all mating ends of the contacts are at the same level. Route the wires free of tension and fasten them.
Benennung Description Dénomination
Typ/ab Type/from Type/ a partir de
Mjfcifss!
PR Litronic LR Litronic RL Litronic
Wiring installation guidelines Datum Edition Date
01 04
ITT-Cannon plug
Blatt Page Feuille
2.3.02.01