INDEX (Cont.) FRONT SYSTEM (Except FWD) Axle Steering Gear Steering Knuckles Tie Rods and Toe-in FRONT-WHEEL DRIVE Front Axie Outer Drive Assembly Outer Drive Housing, King Pins, Axle Shafts and Spindle Housing Differential and Bevel Gear Assembly Transfer case Steering Gear HYDRAULIC SYSTEM Adjustment Control Valve Fluid and Filters Pump Rockshaft POWER TAKE-OFF REAR AXLE TRANSMISSION Overhaul Remove and Reinstall
L175
L210
L225
1 4 3 2
1 4 3 2
1 4 3 2
L225DT
L260 1 4 3 2
5 6 7 8 9 10 153 164 150 159 169 146 135
155 165 151 162 171 148 137
153 164 150 159 169 146 135
153 164 150 159 169 146 135
157 167 152 162 173 149 139
99 97
108 106
99 97
99 97
115 113
DUAL DIMENSIONS This service manual provides specifications in both the U.S. Customary and Metric (SI) systems of measurement. The first specification is given in the measuring system perceived by us to be the preferred system when servicing a particular component, while the second specification (given in parenthesis) is the converted measurement. For instance, a specification of "0.011 inch (0.28 mm)" would indicate that we feel the preferred measurement, in this instance, is the U.S. system of measurement and the metric equivalent of 0.011 inch is 0.28 mm.
CONDENSED SERVICE DATA G EN ERAL Engine Make Engine Model Number of Cylinders Bore (mm) (Inches) Stroke (mm) (Inches) Displacement (cc) (Cubic Inches) Compression Ratio TUNE-UP Valve Tappet Gap (Cold) (mm) (Inch) Injection Timing (BTDC) Timing Mark Location Injection Pressure (MPa) (PSI)
L175 Own Z750-A 2 76 3 82 3-7/32 743 45.3 21:1
L210 Own ZllOOA 2 88 3-15/32 88 3-15/32 1070 65.3 20:1
L225 Own DllOOA 3 76 3 82 3-7/32 1115 68.3 21:1
L225DT Own DllOOA 3 76 3 82 3-7/32 1115 68.3 21:1
L260 Own Z1300 2 90 3-17/32 100 3-15/16 1272 11.1 21.5:1
0.18 0.22 0.007-0.009 25° Flywheel 13.8 2000
0.20-0.25 0.008-0.010 24° Flywheel 13.8 2000
0.18-0.22 0.007-0.009 25° Flywheel 13.8 2000
0.18-0.22 0,007-0.009 25° Flywheel 13.8 2000
0.20-0.25 0.008-0.010 20° Flywheel 11.73 1700