Section 3
Routine Maintenance
Greasing *(3000 Series Machines) * Hydraulic Lift and 3-Point Linkage
3-5
! WARNING
*
You will be working close into the machine for these jobs. Lower the equipment. Remove the starter key and disconnect the battery. This will prevent the engine from being started. Make sure that the parking brake is engaged.
3-5
Hydraulic lift cross-shaft Grease points 5 and 6. Hydraulic lift rams Grease points 7 to 10.
Chock all four wheels before getting under the machine.
Three point linkage lift rods Grease at nipples 11 and 12. On later machines grease at nipples 11, 12, 13 and 14 (lift collars A and B to access nipples 13 and 14). On machines with heavy duty linkage grease points 15 and 16 also.
13-3-1-9
Note: Ladder hitch and trailer coupling omitted for clarity.
*
Section 3
Rear Suspension Cylinder Pivots
Stabilizers (standard type) Grease at point 17.
Grease points 1 to 4.
Note: Where standard type stabilizers are fitted to both sides of the machine, there will be a grease point on each one. *
Rear PTO Drive Shaft Bearing Grease point 18. Do not exceed 2 to 3 strokes of the grease
*
3
1
2
A
5 I
B
A
B
6 II
7
A
III
8 *
%
^
! A ÂŁ
4
B
@ 9
0
B
&
$
A286030
9803/8020
Issue 2*