Figure 10-120-5
HYDRAULIC/HYDROSTATIC SYSTEM (CONT’D) Replacing Hydraulic Fluid (Cont’d)
WARNING
2
Hydraulic fluid escaping under pressure can have sufficient force to enter a person’s body by penetrating the skin. This can cause serious injury and possible death if proper medical treatment by a physician familiar with this injury is not received immediately.
1
W-2145-0290 N-19018
WARNING Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-1285
Figure 10-120-4
Disconnect the hose (Item 1) [Figure 10-120-5] from the case drain filter located on the left drive motor. Use a plug and cap on the filter and case drain hose to prevent leakage. Remove the case drain filters (Item 2) [Figure 10-120-4] & [Figure 10-120-5] and drain the fluid into a container. Replace the hydraulic/hydrostatic filter element. (See Replacing Hydraulic/Hydrostatic Filter on Page 10-1201.) Replace both hydrostatic motor case drain filters (Item 2) [Figure 10-120-4] & [Figure 10-120-5]. When the fluid is removed from the reservoir, reconnect the hose to case drain filters.
2
Add the correct fluid to the reservoir until the fluid level is at the center of the sight gauge (Do not overfill). Lower the operator cab. (See Lowering The Operator Cab on Page 10-30-2.) 1
Start the engine and operate the loader hydraulic controls. Stop the engine and check for leaks.
N-19017
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Check the fluid level in the reservoir and add as needed.
Drain the hydraulic fluid reservoir. (See Fluid Removal on Page 20-80-1.) Disconnect the hose (Item 1) [Figure 10-120-4] from the case drain filter located on the reservoir. Use a plug and cap on the filter hose and case drain hose to prevent leakage.
10-120-2
773 Bobcat Loader Service Manual