INSP ADJ
FUEL SYSTEM/POWER UNIT
E
Water separator inspection 1. Inspect: • Water separator 1 Water accumulation → Drain. NOTE: To drain the water, remove the drain plug.
POWER UNIT Valve clearance adjustment The following procedure applies to all of the valves. NOTE: • Valve clearance adjustment should be made on a cold engine, at room temperature. • When the valve clearance is to be measured or adjusted, the piston must be at top dead center (TDC) of the compression stroke. 1. Remove: • Ignition coils • Spark plugs • Cylinder head cover • Cylinder head cover gasket Refer to “CAMSHAFTS” in Chapter 5. 2. Install: • Dial gauge needle • Dial gauge stand 1 (into spark plug hole #1) • Dial gauge 2
2
Dial gauge stand: 90890-06583 Dial gauge needle: 90890-06584 Dial gauge stand set: YB-06585/90890-06585 Dial indicator gauge: YU-03097 Dial gauge set: 90890-01252
1
3-8