To Main Table of Contents
To Section Table of Contents
Fig. 2-41
Fig. 2-44
AP118B
13. Remove the screw securing the servomotor mounting plate to the air-intake silencer; then pull the mounting plate forward and up to remove it from the silencer. Lay the mounting plate aside out of the way.
AN614D
17. Disconnect the impulse hose from the crankcase. 18. Loosen the engine torque bumper; then remove the left-side rear engine nut and washer. Fig. 2-45
Fig. 2-42
AN610D AP127
14. Lift the silencer cover and remove the CDI unit; then lay the unit aside out of the way. 15. Remove the two APV drain hoses and route them out of the way.
19. Disconnect the engine and timing sensor wiring harnesses from the main wiring harness. Remove the spark-plug caps from the spark plugs. Remove the cap screw securing the two ground wires to the magneto housing cover. 20. Remove the E-clip and washer securing the oil-injection cable; then disconnect the oil-injection cable from the oil-injection pump. Disconnect the oil-supply hose and the oil-output hose from the pump and plug the hoses to prevent oil drainage.
Fig. 2-43
Fig. 2-46
AP128A
16. Label the carburetors. Loosen the flange clamp securing each carburetor to its flange; then remove the carburetors from the intake flanges. Position the carburetors to one side in an upright position.
2-12
AN392D