Fig. 2-146
Fig. 2-149
AN161
AN157
7. Remove the three Allen-head cap screws securing the stator to the stator plate.
11. Remove the thermostat cover; then remove the thermostat from the water manifold.
8. Remove the rubber grommet from the crankcase and slide the stator free of the crankshaft.
NOTE: The thermostat is designed to open at 50°C (122°F). It should be checked for proper operation before installing (see Section 3).
Fig. 2-147
12. Remove the water manifold assembly. Fig. 2-150
AN160
9. Remove the two Allen-head cap screws securing the stator backing plate to the crankcase. Fig. 2-148
AN156
13. Remove each cylinder head; then account for the two O-rings under each head. 14. For assembly purposes, number the three heads and cylinders using a marker. Start from the MAG-side. Fig. 2-151
AN158
10. Remove the two screws securing the timing sensor; then loosen the screw securing the wiring harness retainer tab. Remove the timing sensor from the crankcase. AN209
2-35
2