BRAKE PAD INSPECTION/DRIVE CHAIN
II~gj
I_I
2E161
BRAKE ADJUSTMENT
®
BRAKE PAD INSPECTION 1. Apply the brake lever. 2. Measure: • Brake pad thickness ® Out of specification ~ Replace brake pads as a set. (see page 4-27)
~ I
I I
I I
I I I I
_J
Wear limit: I~ ~ 5.2 mm (0.2 in) v
NOTE: _________________________ Adjust brake every 40 hours of operation, or whenever the brake lever becomes loose during operation.
3. Measure: • Distance "L" Out of specification --) Adjust. Distance UL U
69.0
~
71.0 mm (2.72
~
2.8 in)
4. Adjust: • Distance "L" Adjustment steps: • Loosen the locknut CD. • Turn the adjuster CV in or out until the specified distance is obtained. Turning in
Distance uL u is increased.
Turning out
DistanceuL is decreased. U
• Tighten the locknut CD.
2E171
DRIVE CHAIN Oil Level Inspection 1. Place the machine on a level surface. 2. Remove:
2-18
• Muffler 3. Place a rag under the checking hole level). 4. Remove: • Checking bolt CV • Gasket (checking bolt)
CD
(oil