Page 40

0100 YRM 1735

Transmission Replacement 11. Remove flange head capscrew, yoke, and spacer from transmission. Make sure to not damage the stat-o-seal. See Figure 33. NOTE: Note position of oil seal prior to removal to aid in installation. 12. Remove oil seal from transmission housing. See Figure 33.

INSTALL WARNING The transmission is heavy. Make sure that any lifting device has enough capacity to lift the weight. The transmission can weigh approximately 84 kg (185 lb). 1. Using a lifting device, install transmission in lift truck frame. Place a block under the transmission housing to support the transmission. 2. Install oil seal on back of transmission housing. See Figure 33. 3. Install new stat-o-seal on yoke. See Figure 33. 4. Install spacer, yoke, and flange head capscrew on back of transmission. Tighten capscrew to 77 N•m (57 lbf ft). See Figure 33.

NOTE: DRIVE AXLE NOT SHOWN FOR CLARITY. 1. 2. 3. 4. 5.

MOUNT BRACKET CAPSCREW WASHER SNUBBING WASHER ISOLATOR Figure 32. Rear-Mount, Transmission

WARNING The transmission is heavy. Make sure that any lifting device has enough capacity to lift the weight. The transmission can weigh approximately 84 kg (185 lb).

1. 2. 3. 4. 5. 6.

FLANGE HEAD CAPSCREW STAT-O-SEAL YOKE OIL SEAL SPACER TRANSMISSION HOUSING Figure 33. Drive Shaft Yoke

10. Use the lifting device to carefully lift the transmission from the frame. Slip the transmission output yoke out of the transmission. Make sure to not damage the seal. 39

Profile for 1639589

YALE D810 GLP20SX LIFT TRUCK (EUROPE) Service Repair Manual  

YALE D810 GLP20SX LIFT TRUCK (EUROPE) Service Repair Manual  

Profile for 1639589
Advertisement