Page 10

0100 YRM 1735

Hood, Seat, and Side Covers Replacement Legend for Figure 6

NOTE: RIGHT SIDE SHOWN. PROCEDURES ARE THE SAME FOR LEFT SIDE. A. STEP PLATE FOR LIFT TRUCK MODELS GLC030-035VX, GLC040SVX (D809) B. STEP PLATE AND STEP COVER FOR LIFT TRUCK MODELS GLP/GDP16-18VX, GLP/GDP20SVX (GLP/ GDP030-035VX, GLP/GDP040SVX) (D810) 1. STEP PLATE 2. CAPSCREW 3. RIGHT REAR COVER

4. RIGHT STEP COVER 5. CLIP NUT

10. Remove capscrews, washers, and left and right front cover from frame. •

See Figure 4 for lift truck models GLC030-035VX, GLC040SVX (D809)

See Figure 5 for lift truck models GLP/ GDP16-18VX, GLP/GDP20SVX (GLP/ GDP030-035VX, GLP/GDP040SVX) (D810)

11. Use tilt lever and fully lower steering column. See Figure 2. 12. Remove upper steering column cover by pulling up on upper steering column cover to release latches (one on either side), and pulling cover away from steering column. See Figure 7. 13. Remove five fasteners securing dash to the top of cowl. See Figure 7. Remove four clips, located underneath dash, that attach dash to the kick panel. Lift to remove dash. • •

See Figure 4 for lift truck models GLC030-035VX, GLC040SVX (D809) See Figure 5 for lift truck models GLP/ GDP16-18VX, GLP/GDP20SVX (GLP/ GDP030-035VX, GLP/GDP040SVX) (D810)

14. Lift kick panel and remove from truck. 15. Remove three capscrews and clip nuts from seal plate. Remove seal plate from frame. 16. Remove two capscrews and washers from cover plate and remove seat box. Disconnect seat wire harness connector. See Figure 8.

CAUTION When removing the seat from the hood, DO NOT use an impact wrench to remove the capscrews. Damage can be caused to the threads on the screws and in the holes. NOTE: Before removing seat from hood, tag or mark holes that mount seat to hood. This will aid in correctly installing seat to hood. 17. Remove four capscrews and washers attaching seat to hood. Lift seat up and remove from hood. 18. Remove radiator cover and seals from lift truck frame. •

See Figure 4 for lift truck models GLC030-035VX, GLC040SVX (D809)

See Figure 5 for lift truck models GLP/ GDP16-18VX, GLP/GDP20SVX (GLP/ GDP030-035VX, GLP/GDP040SVX) (D810)

19. Remove two capscrews and hood latch striker bolt from mounting bracket. See Figure 9. 20. Remove two capscrews and hood latch from hood. See Figure 9. 21. Remove capscrews and washers at the top of gas springs. Remove gas springs from hood. 22. Remove hinge screws, located in the rear of the hood. See Figure 10. 23. Remove hood from lift truck.

9

Profile for 1639589

YALE D809 GLC035VX LIFT TRUCK Service Repair Manual  

YALE D809 GLC035VX LIFT TRUCK Service Repair Manual  

Profile for 1639589
Advertisement