Page 33

Engine Replacement

CAUTION When separating the engine away from the transmission, place a piece of plywood in front of radiator. This will keep the engine from damaging the radiator.

CAUTION Keep the engine level when the engine is separated from the transmission so the drive plate is not damaged. 26. Use the lifting device to carefully move the engine away from the torque converter. Make sure all hoses, wires, and cables are disconnected from the engine, then lift the engine from the frame and place engine on blocks. 27. Remove torque converter from torque converter housing.

INSTALL WARNING The engine is heavy. Make sure that any lifting device has enough capacity to lift the engine. The engine can weigh approximately 194 kg (428 lb).

CAUTION Keep the engine level when installing the engine to the transmission so the drive plate is not damaged. 1. Install torque converter in torque converter housing. 2. Connect lifting device to engine and lift engine into frame.

100 YRM 1120 6. Install six lock washers and six capscrews on flywheel housing and torque converter housing from flywheel housing side. Tighten capscrews to 38 N•m (28 lbf ft). See Figure 25. 7. Install four flange bolts on torque converter housing and flywheel housing from transmission side. Tighten bolts to 38 N•m (28 lbf ft). See Figure 25. 8. On trucks equipped with a GM 2.4L engine, install starter bolt. 9. Install converter housing cover, two washers, and two capscrews on torque converter housing. Tighten capscrews to 19 N•m (168 lbf in). See Figure 25. NOTE: For procedures to install exhaust pipe to exhaust manifold for lift trucks equipped with a Mazda 2007 emissions compliant engine and for lift trucks built after January, 2010 equipped with a Mazda engine, see Gasoline Fuel System, Mazda FE and F2Emission Compliant Engines 900 YRM 1325 or LPG Fuel System, Mazda FE and F2 Emission Compliant Engines 900 YRM 1326. 10. Install exhaust pipe to exhaust manifold. See Exhaust System Repair. 11. For lift trucks built before 2007, equipped with Mazda engines - Connect the ECM connector and governor controller to lift truck frame. 12. On lift trucks equipped with a Mazda 2.0L or 2.2L engine, install ECM bracket with ECM attached and two bolts on engine block.

WARNING

3. Install isolators on engine mounts. Install the nuts and bolts for the engine mounts to secure engine to frame. See Figure 26 and Figure 27. Tighten the nuts to 150 N•m (110 lbf ft).

All fuels are very flammable and can burn or cause an explosion. DO NOT use an open flame to check the fuel level or to check for leaks in the fuel system.

4. Use access port on side of engine and install bolts to hold torque converter to flywheel. Tighten bolt to 56 N•m (41 lbf ft). See Figure 24.

Breathing fuel vapor may cause nausea, unconsciousness or death. Long term exposure to gasoline vapors may cause liver or kidney damage and cancer. Avoid breathing vapor.

NOTE: Perform Step 5 for lift trucks equipped with iron transmission housing. 5. Align transmission bell housing holes with flywheel housing holes and install capscrews. Tighten capscrews to 38 N•m (28 lbf ft). NOTE: Perform Step 6 through Step 9 for lift trucks equipped with aluminum transmission housing.

32

No smoking.

13. Connect the wires and wiring harnesses at the engine. Remove caps from fuel lines and connect the fuel lines at the engine.

Profile for 1637912

YALE B875 GDP35VX LIFT TRUCK Service Repair Manual  

YALE B875 GDP35VX LIFT TRUCK Service Repair Manual  

Profile for 1637912
Advertisement