Page 7

Oil Filling for Tilt System

100 YRM 1100

11. Lower cab. See Lower Cab.

13. Connect battery ground lead.

12. Install doors.

14. Install side panels.

Oil Filling for Tilt System CAUTION When oil has been added, put oil-absorbing material around filler plug before lowering cab. Excess oil may bleed out of relief valve, which is fitted in filler plug. NOTE: When cab does not reach the maximum opening the oil level is low. 1. Lower cab until it locks in partially open position. See Lower Cab. 2. Put pump lever connection in fully down position to gain access to the fill cap. See Figure 8. 3. Remove fill cap. See Figure 8. 4. Add hydraulic oil into filler opening until level is within 30 to 35 mm (1.18 to 1.38 in.) of top of reservoir. See Figure 9.

1. FILL CAP Figure 8. Hand Pump

5. Install fill cap. See Figure 8. 6. Raise cab and make sure that maximum tilt can be reached. See Raise Cab. 7. Repeat procedure if necessary. 8. Lower cab until it is in fully lowered position and completely latched.

Figure 9. Cab Tilt Label

6

Yale d876 gdp100db lift truck (europe)service repair manual  
Yale d876 gdp100db lift truck (europe)service repair manual  
Advertisement