100 YRM 1120 NOTE: Step 6 and Step 7 apply to lift truck models GLP/GDP20-35VX (B875) equipped with a variable displacement pump (VDP): 6. Remove the hydraulic supply (suction) hose between the variable displacement pump and hydraulic tank. Put a cap on the hydraulic tank fitting. See Figure 28. 7. Remove the hydraulic supply hose, load sense line, drain case line, and hydraulic inlet line from the variable displacement pump. Put cap on all variable displacement pump and hose openings. See Figure 28.
Transmission Replacement 8. Connect a lifting device to support the transmission. 9. Remove the capscrew, washer, snubbing washers, and isolators from the mount bracket at the rear of the transmission. See Figure 29. 10. Use a lifting device to carefully lift the transmission out of the frame. Slip the transmission output yoke out of the transmission. Make sure to not damage the seal.
WARNING The transmission is heavy. Make sure that any lifting device has enough capacity to lift the weight. The transmission can weigh approximately 317 kg (699 lb).
1. 2. 3. 4. 5. 6.
TRANSMISSION HOUSING VARIABLE DISPLACEMENT PUMP LOAD SENSE LINE HYDRAULIC INLET LINE DRAIN CASE LINE HYDRAULIC SUPPLY (SUCTION) HOSE
Figure 28. Hydraulic Hose Connections, Lift Truck Models GLP/GDP20-35VX (B875) Equipped With Variable Displacement pump
NOTE: DRIVE AXLE NOT SHOWN FOR CLARITY. 1. 2. 3. 4. 5.
MOUNT BRACKET CAPSCREW WASHER SNUBBING WASHER ISOLATOR
Figure 29. Rear Mount - Transmission
35