REMOTE START SWITCH
A
Procedure The tool listed will be needed to do the following procedure: MEL1429 – Remote Start Switch
1 Put jackstands under the front axles and rear corners of the frame before running the engine for service. Failure to use jackstands can allow the machine to fall or move and cause injury or death.
W–2017–0286
1
The remote start switch is required when the operator cab is in the raised position for service and the service technician needs to start the engine. (Example: Checking the hydraulic/hydrostatic system). Lift and block the loader. (See Page 1–4.) Raise the lift arms and install an approved lift arm support device. (See Page 1–7.)
N–15866
B Never work on a machine with the lift arms up unless the lift arms are secured by an approved lift arm support device. Failure to use an approved lift arm support device can allow the lift arms or attachment to fall and cause injury or death. W–2059–0598
Raise the operator cab. (See Page 1–9) The operator cab wire harness connectors must be separated from the engine wiring harness connector under the cab, connect the remote start switch connectors (Item 1) [A] to the wire harness connectors. Start the engine using the remote start switch [B].
N–15867
Revised Mar. 99
–1–29–
963 Bobcat Loader Service Manual