HYDRAULIC CYLINDER REPAIR
A
Disassembly NOTE: The following procedure can be used for both the lift and tilt cylinders. The tools listed will be for either the lift or tilt cylinders. The tools listed will be needed to do the following procedure: MEL1075 – Gland Nut Wrench Put the base end of the cylinder in a drain pan. Move the rod in and out to remove the fluid from the cylinder barrel.
B–07640
Put the base end of the cylinder in a vise. Remove the end cap from the cylinder using the special tool [A].
B Remove the rod with the end cap and piston from the cylinder barrel. The tilt cylinder is a cushion type cylinder and has a tapered piston [B].
B–07641
The lift cylinder has a long sleeve on the rod [C].
C
B–07642
D
Put the rod end of the shaft in the vise and remove the nut [D].
B–03670
Revised Nov. 85
–2–8–
943 Loader Service Manual