HYDRAULIC/HYDROSTATIC SYSTEM
A
Checking And Adding Fluid Use only recommended fluid in the hydraulic system. (See SPECIFICATIONS Page 9–1 for the correct fluid.) To check the reservoir fluid level, use the following procedure:
2
Stop the loader on a level surface. Lower the lift arms and tilt the Bob–Tach fully back.
1
Stop the engine. Remove the dipstick (Item 1) [A].
P–03972
B
The fluid level must be between the marks on the dipstick [B]. If fluid is needed, remove the fill cap (Item 2) [A].
P–03973
C
Clean the hydraulic reservoir fill screen [C]. Add the fluid as needed to bring the level to the top mark on the dipstick [B].
P–03976
Replacing Hydraulic/Hydrostatic Filter
D
See the SERVICE SCHEDULE Page 1–3 for the correct service interval. Open the rear door.
1
Use a filter wrench to remove the filter element (Item 1) [D]. Clean the surface of the filter housing where the element seal contacts the housing. Put clean oil on the rubber seal of the filter element. Install and hand tighten the filter element.
P–10318
Revised Feb. 99
–1–24–
753, 753H BICS Loader Service Manual