PRECAUTIONS Parts Requiring Angular Tightening
Parts Requiring Angular Tightening I a) b) c) d) I I I
NHEM0001
Use an angle wrench for the final tightening of the following engine parts: Cylinder head bolts Main bearing cap bolts Connecting rod cap nuts Crankshaft pulley bolt Do not use a torque value for final tightening. The torque value for these parts are for a preliminary step. Ensure thread and seat surfaces are clean and coated with engine oil.
GI MA
LC EC FE AT
Liquid Gasket Application Procedure 1.
2. I
AX NHEM0002
Use a scraper to remove all traces of old liquid gasket from mating surfaces and grooves. Also, completely clean any oil from these areas. Apply a continuous bead of liquid gasket to mating surfaces. (Use Genuine RTV silicone sealant or equivalent. Refer to GI-52.) Be sure liquid gasket diameter is as specified in this manual.
SEM164F
3. 4. 5.
Apply liquid gasket around the inner side of bolt holes (unless otherwise specified). Assembly should be done within 5 minutes after coating. Wait at least 30 minutes before refilling engine oil and engine coolant.
SU BR ST RS BT HA SC EL
AEM080
IDX
EM-3