FZ008
0742-672A
12. Remove the ground wire form the starter motor; then remove the two cap screws (A) securing the MAG-side starter motor bracket to the engine. Remove the bracket and starter motor and account for the rubber damper.
15. Move the engine forward enough to remove the cap screws (C) securing the rear MAG-side engine mounting bracket to the engine; then remove the bracket.
! CAUTION Use care when moving the engine forward not to damage the wiring harness.
16. Remove the cap screws and lock nuts securing the headlight support bracket to the front upper frame; then remove the bracket and account for the mounting hardware. 17. Loosen the carburetor flange clamps and remove the carburetors from the intake flanges; then remove the clamp and disconnect the impulse line from the crankcase. FZ024A
13. Remove the two cap screws (B) securing the PTOside starter motor bracket to the engine; then remove the bracket and account for the rubber damper.
FZ006
! CAUTION
FZ023A
NOTE: At this time, route the starter motor ground wire out from the engine plate.
14. Remove the cap screw (A) securing the rear MAG-side engine mounting bracket to the chassis; then remove the three remaining lock nuts (B) securing the engine plate to the chassis.
After the carburetors have been removed, secure them in an upright position to avoid fuel running out of the vent tubes.
18. Disconnect the oil-injection cable from the oil pump and account for the E-clip and washer; then disconnect the oil supply hoses from the pump and plug the hoses to prevent leakage. 19. Remove the cap screw and lock nut securing the wiring harness clamp to the chassis; then remove the spark plug wires from the spark plugs. Disconnect the coil wire and CDI connectors and route and secure the harness to the engine to avoid damage when removing the engine from the chassis. 2-41
2