Page 54

HYDRAULIC / HYDROSTATIC SYSTEM (CONT’D)

Breather Cap

Removing And Replacing Hydraulic Charge Filter

For the correct replacement interval (See SERVICE SCHEDULE on Page 10-70-1.)

The charge filter is located under the cab. Raise the cab. (See Lowering on Page 10-30-3.) For the correct service interval SCHEDULE on Page 10-70-1.)

(See

SERVICE Figure 10-120-8

Figure 10-120-7 1

P-1497 P-1497

1

N-20566 P-64255

Raise the cab. (See Raising on Page 10-30-2.)

Remove and discard the hydraulic breather (Item 1) . Install new breather. Be sure baffle is installed under breather cap (Inset) [Figure 10-120-8].

Remove the filter (Item 1) [Figure 10-120-7].

Lower the cab. (See Lowering on Page 10-30-3.)

Clean the surface of the filter housing where the filter seal contacts the housing.

WARNING

Put clean oil on the seal of the new filter element. Install and hand tighten the filter element. Start the engine and operate the loader hydraulic controls.

WARNING

AVOID INJURY OR DEATH Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-0807

Hydraulic fluid escaping under pressure can have sufficient force to enter a person’s body by penetrating the skin. This can cause serious injury and possible death if proper medical treatment by a physician familiar with this injury is not received immediately. W-2145-0290

Stop the engine and check for leaks at the filter. Lower the cab. (See Lowering on Page 10-30-3.) Check the fluid level in the reservoir and add as needed. (See Checking And Adding Fluid on Page 10-120-1.)

10-120-5

T140 Service Manual

Bobcat t140 compact track loader service repair manual sn a3l711001 a3l719999  
Bobcat t140 compact track loader service repair manual sn a3l711001 a3l719999  
Advertisement